Dragon Night Light - 3D-printed figure with a flickering glow

Dragon night light with a flickering glow and a sculpted 3D-printed body

The body is 3D printed in PLA, with scales and wings modeled in relief rather than painted on. Inside, an LED flickers like a low flame, so the light shifts instead of sitting flat. It charges over USB and runs cordless for up to ten hours.

Why choose this dragon night light?

It reads as an object on the shelf during the day and as a light source at night. That makes it useful in a bedroom, a gaming setup or a hallway that needs a low glow rather than a lamp.

• Flickering LED: the output rises and falls like flame instead of holding a steady beam
• 3D-printed PLA: a layered, sculpted body with visible detail across the wings and scales
• USB rechargeable: top it up from any USB port and put the cable away again
• Up to 10 hours cordless: enough for a full evening and a night left on
• 20 x 10 cm footprint: small enough for a desk, a shelf or a bedside table

Once charged, it stays where you put it with nothing plugged in.

The warm output is low enough to leave on through the night without lighting the whole room. Because it is cordless, it moves easily from a desk to a bedside table or out to a table on a covered porch. The flat base keeps it stable on any hard surface.

Specifications

• Material: 3D-printed PLA
• Power source: USB rechargeable
• Runtime: up to 10 hours per charge
• Light source: LED with flicker effect
• Dimensions: 20 x 10 cm (7.9 x 3.9 in)

Charge it once and let the dragon light your evenings.