Shower Barrier – Flexible Silicone Water Stop Strip for Tiled Floors

Shower Barrier – Keeps the Water on the Shower Side of the Room

A flexible silicone strip that sticks to the floor at the edge of the shower and holds the water back. It bends around corners and follows a curved enclosure, so it works with a walk-in as well as a square tray. Available in one and two meter lengths, in white, black or gray.

Why choose a silicone shower barrier?

A wet bathroom floor is a slipping risk and a slow path to damage under the tile. A low strip at the boundary stops the water traveling without building a threshold you have to step over. Fitting it is a ten-minute job with no tools.

• Watertight seal — the flexible lip presses to the tile and holds water back.
• Bends to the layout — follows curves, corners and an open walk-in edge.
• No tools needed — position, press and adjust before the adhesive sets.
• Low profile — sits flat enough to step over without noticing it.
• Two lengths, three colors — one or two meters in white, black or gray.

The rest of the bathroom stays dry, and nobody has to mop.

Measure the open edge of your shower first and choose the length that covers it with a little to spare. Clean and dry the tile thoroughly, then press the strip down along the full run without stretching it. Leave it to cure for a day before the first shower so the adhesive reaches full strength.

Specifications

• silicone
• lengths 1 m (3.3 ft) and 2 m (6.6 ft)
• flexible, bends around corners
• adhesive mounting, installation guide included

Measure the edge and seal it off.