Glass Door Lock – Stainless Steel Slide Bolt for 10-14 mm Panels

Glass Door Lock – A solid bolt on a frameless door, without drilling the glass

A stainless steel sliding bolt made for frameless glass doors with a panel thickness of 10 to 14 mm. It clamps over the seam rather than through the pane, so the glass stays intact. At 700 grams it has the weight you expect from a lock rather than a latch.

Why choose a slide bolt for glass doors?

Most door hardware assumes a wooden frame with something to screw into. A glass door gives you neither, which usually leaves a handle and nothing else. This bolt clamps onto the gap between panel and jamb and gives you a real closing action.

• Fits 10-14 mm glass — Covers the common thicknesses for interior and shower panels.
• Clamps the seam — Works on door gaps of 5 to 10 mm, with no holes in the glass.
• Stainless steel body — Handles damp rooms without pitting or rust streaks.
• 700 grams — The mass and travel of a proper bolt, not a token catch.
• Straightforward fitting — Position, tighten and slide; no special tools needed.

A frameless door that finally closes properly.

Measure both the panel thickness and the gap between the panel and the jamb before ordering. Fit it at a height where the bolt travel is not blocked by a hinge or a handle. Retighten the clamp once after a week of use, as any fitting settles.

Specifications

• stainless steel
• suits glass thickness 10-14 mm
• suits a door seam of 5-10 mm
• weight 700 g
• clamp fitting, no drilling

Measure the panel and fit the bolt.