Bike Wall Hook – Steel Pedal Mount Holding Up to 150 lb at a 25 Degree Tilt

Bike Wall Hook – Gets the Bike Off the Floor and Out of the Way

This hook screws into the wall and carries the bike by its pedal axle, holding it horizontally against the wall. The frame never touches the mount, so nothing rubs the paint. The 25 degree tilt lets you stack several bikes above one another in the same stretch of wall.

Why choose a wall-mounted bike hook?

A bike parked on the floor takes up more room than anything else in a garage or hallway. Hanging it horizontally puts it flat against the wall where nothing walks into it. Installation is one hook and a couple of screws, not a rack you have to assemble.

• High-carbon steel body — rated to hold up to 150 lb / 68 kg on a solid wall.
• 25 degree angled arm — bikes hang clear of each other, so you can stack them vertically.
• Pedal-axle support — the load sits on the pedal, not on the frame or the paintwork.
• Two tyre rests included — keep the wheels off the wall and stop the bike swinging.
• Expansion screws in the box — drill, set, tighten, done — no separate hardware run.

One afternoon with a drill and the floor is yours again.

Mark the holes, drill to 32 mm with an M6 bit, set the expansion screws and tighten the hook down before hanging anything on it. Fit the two tyre rests afterwards, using the bike itself to find the right height. It suits road bikes, mountain bikes and e-bikes with a pedal axle up to 20 mm.

Specifications

• ST37 high-carbon steel
• maximum load 68 kg / 150 lb on solid walls
• hook length 140 mm (5.5 in), weight 900 g
• includes 1 pedal support, 2 tyre rests and expansion screws

Put the drill to the wall and hang it up.